DURKOPP ADLER 878-M PREMIUM - Controller; Fitting the Control Unit

Setup
Operating Instructions 878-M PREMIUM - 02.0 - 02/201858
7.7 Controller
7.7.1 Fitting the control unit
Fig. 35: Fitting the control unit
1. Screw the control unit (2) onto the 4 screw holders (3) under the
table top.
2. Clamp the power cable of the control unit (2) into the strain
relief mechanism (1).
3. Screw the strain relief mechanism (1) under the table top.
3
2
1
(1) - Strain relief (2) - Control unit
(3) - Screw holder