DURKOPP ADLER 878-M PREMIUM - Deleting a Program

Settings via the software
Operating Instructions 878-M PREMIUM - 02.0 - 02/2018 91
3. Press OK to load the program number.
Or:
Select another program number using 
/ or input a
program number using the keypad keys 0 - 9 and then press
OK.
 The program number is loaded.
The following display appears, with the program number
flashing:
Fig. 61: Display after specifying the program number
4. Load the desired changes into the new program.
5. Press the ESC key.
 The controller exits Programming mode and reverts to Auto-
matic mode.
8.6.8 Deleting a program
The selected program is deleted.
1. Press the key.
 The softkey menu appears.
Fig. 62: Softkey menu
2. Press the key.
3. Press the ESC key.
 The controller exits Programming mode and reverts to Auto-
matic mode.