Setup
Operating Instructions 878-M PREMIUM - 02.0 - 02/2018 67
7.13.4 Connecting the control unit
Connect the control unit as follows:
• Insert the plug of each connecting cable into the sockets on
the back of the control unit.
• Connect the control unit to the power supply using the power
cable.
1. Connect the control unit as specified in the interconnection
diagram, Interconnection diagram, p. 88
7.14Lubrication
All wicks and felt bits of the machine head are soaked in oil at the
factory. This oil is conveyed to the reservoir during use. This is
why you should avoid filling too much oil during initial filling.
NEBEZPEČÍ
Risk of death from electric shock!
Disconnect the power plug before connecting the
control unit.
Make sure the power plug cannot be accidentally
plugged back in.
WARNING
Skin damage due to contact with oil!
Oil can cause a rash if it comes into contact with
skin.
Avoid any skin contact with the oil.
If oil has come into contact with your skin, wash
the affected areas thoroughly.
To Next Page
Loading...
Need help?
General
