Setup
Operating Instructions 878-M PREMIUM - 02.0 - 02/201868
Fig. 45: Oil level indicator
1. Fill oil through the filler hole (1) to a maximum of 2 mm below
the maximum level marking (2).
Required oil:
Only DA 10 or equivalent oil should be used for the machine, which
has the following properties:
• Viscosity at 40 °C: 10 mm²/s
• Flash point: 150 °C
(1) - Filler opening
(2) - Maximum level marking
(3) - Minimum level marking
NOTICE
MMachine damage possible due to incorrect oil level.
Too little or too much oil can damage the machine.
During initial filling, only pour in oil up to 2 mm below the
maximum level marking.
NOTICE
Machine damage possible due to incorrect oil.
An incorrect oil type can cause damage to the machine.
Only use oil specified in the operating instructions.
CAUTION
Risk of pollution from oil.
Oil is a pollutant and must not enter the sewage
system or the soil.
Collect waste oil carefully and dispose of it and
oily machine parts in accordance with the
applicable statutory regulations.
To Next Page
Loading...
Need help?
General
