Settings via the software
Operating Instructions 878-M PREMIUM - 02.0 - 02/2018 79
8.4.3 Sewing
Altering parameters whilst within the seam
1. Move the pedal to the 0 position.
2. Change the desired parameter on the control panel.
3. Press the pedal forwards and sew.
The seam will be sewn using the altered parameter value.
8.5 Automatic mode
Program numbers 001 to 999.
1. Use
/ to select the Program parameter.
2. Use
/ to select the program number 1 or another one (if
available).
The controller switches to automatic mode and the following
information appears on the display:
Fig. 52: Displey in Automatic mode
The following table shows the individual symbols on the display
and the functions of the keys on the control panel.
To Next Page
Loading...
Need help?
General
