10-03-2022 4812331840EN 14
Safety – During operation
Operation near edges
When driving near edges, at least 2/3 of the machine’s width
should be on ground with full bearing strength.
Remember that the machine’s centre of gravity
moves outward when steering. For example: it
moves right when you steer left.
Slopes
This angle has been measured on a hard, flat surface with the
machine stationary.
The steering angle was zero, the vibration was switched off and
all tanks were full.
Always take into consideration that loose ground, steering the
machine, vibration on, machine speed across the ground and
raising the centre of gravity can all cause the machine to topple
at smaller slope angles than those specified here
.
To exit the cab in an emergency, release the
hammer located on the rear right post and
break the rear window.
It is recommended that ROPS (Roll Over
Protective Structure) or a ROPS approved
cab is always used when driving on slopes or
unstable ground. Always wear a safety belt.
Avoid driving across slopes.
Always drive straight up and down on slopes.
Fig. Positioning of the drums when
driving near an edge of a slope.
To Next Page
Loading...
Need help?
General
