Maintenance – Planned maintenance
10-03-2022 4812331840EN 98
Hydraulic reservoir – bleeder filter check
If passage in either direction is blocked, clean the
filter with a little diesel oil and blow through with
compressed air until the block is removed, or replace
the cap with a new one.
Always wear protective goggles when working
with compressed air.
Check that the bleeder filter (1) is not clogged. Air
should be able to pass through the cap unobstructed
in the both directions.
Start the engine and check that there is no leakage of the
hydraulic fluid from the filter. Check level of fluid in the slight
glass (2) and top up as required.
Diesel engine – Oil and filter change
Take great care when draining fluid and oil at high
temperatures. Wear protective gloves and goggles.
It is easier to handle the oil drain plug (1) from under the
engine. Drain the oil when the engine is warm. Place a
receptacle that holds at least 15 litres (4 gal) under the drain
plug.
Change the oil filter. Please read the instruction manual for the
engine.
Dispose of the drained oil and filter separately in the
right manner.
Drum cartridge - Cleaning the ventilation screw
Clean the drum's ventilation hole and ventilation screw
(1). The hole is required to eliminate excess pressure
inside the drum.
Fig. Hydraulic fluid tank
1. Filer cap/air filter.
2. Oil sight glass.
Fig. Left side of engine:
1. Drain plug;
To Next Page
Loading...
Need help?
General
