EasyManuals Logo

Dynapac CA25 User Manual

Dynapac CA25
110 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #94 background imageLoading...
Page #94 background image
Maintenance Planned maintenance
10-03-2022 4812331840EN 94
Drum Checking the oil level
Place the roller on a level surface so that the plug (1) and the
drum's number plate are visible on the right side.
The oil level should now reach the sight glass (3).
If necessary, remove the plug (1) and fill to halfway up the sight
glass.
Clean any metal residue from the magnetic plug (1)
before reinstalling it.
See the lubrication specification for the correct oil grade.
Do not overfill with oil risk for overheating.
Radiator Check/Cleaning
Check that the air is circulating through the radiator without
obstacles (1), (2) and (3).
Clean a dirty radiator using compressed air or a high-pressure
water jet.
Clean with compressed air or wash the radiator in the opposite
direction to that of the cooling air.
Be careful when using a high-pressure jet and do not place the
nozzle too close to the radiator.
Wear protective goggles when working with
compressed air or water jets.
Fig. Cylinder, left side
1. Drain/Fill plug
3
Fig. Cylinder, left side
1. Fill plug
2. Drain Plug
3. Sight Glass
2
Fig. Engine compartment
1. Charge air cooler
2. Oil cooler
3. Radiator
1

Table of Contents

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Dynapac CA25 and is the answer not in the manual?

Dynapac CA25 Specifications

General IconGeneral
BrandDynapac
ModelCA25
CategoryConstruction Equipment
LanguageEnglish

Related product manuals