10-03-2022 4812331840EN 16
High pressure cleaning
Do not aim the water jet directly onto electrical components or
instrument panels.
Put a plastic bag over the filling cap of the fuel tank and secure
with an elastic band. This is to avoid pressurised water entering
the vent hole in the filler cap. This could cause malfunctions,
such as blocking of filters.
When washing the machine, do not aim the water jet
directly at the fuel tank cap. This is particularly
important when using a high-pressure jet.
Fire extinguisher
If the machine catches fire, use a ABC-class powder fire
extinguisher. It is also possible to use a BE-class CO2
extinguisher.
Roll Over Protection Structure (ROPS), ROPS-
approved cab.
If the machine is fitted with a Roll Over Protective
Structure (ROPS, or ROPS-approved cab), never
carry out any welding or drilling in the structure or
cab.
Never attempt to repair a damaged ROPS structure
or cab. These must be replaced with a new structure
or cabs.
Welding
When carrying out welding on the machine, the
battery must be disconnected and the electronics
disconnected from the electrical system.
If possible, remove the part(s) to be welded from the machine.
To Next Page
Loading...
Need help?
General
