E15h SPRAYER- Alarm Setup
4.1 RATE ALARMS
4.1.1 ENABLE THE MINIMUM FLOW ALARM
NOTE: To set the MINIMUM FLOW value, see Section 3.3.
• Press MENU
• Press ENTER to select SETUP
• Press LINE 2, the focus is on ALARM SETUP
• Press ENTER to select ALARM SETUP
• Press ENTER to select RATE ALARMS
• Press ENTER to select MIN FLOW ALARM.
An asterisk (*) will be displayed
• Press INC/DEC buttons, to set the alarm ON or OFF
• Press ENTER to accept the changes
4.1.2
ENABLE THE APPLICATION RATE LOW ALARM
• Press MENU
• Press ENTER to select SETUP
• Press LINE 2, the focus is on ALARM SETUP
• Press ENTER to select ALARM SETUP
• Press ENTER to select RATE ALARMS
• Press LINE 2, the focus is on RATE LOW ALARM
• Press ENTER to select RATE LOW ALARM.
An asterisk( *) will be displayed
• Press INC/DEC buttons, to set the alarm ON or OFF
• Press ENTER to accept the changes
4.1.3 SET THE APPLICATION RATE LOW ALARM POINT
• Press MENU
• Press ENTER to select SETUP
• Press LINE 2, the focus is on ALARM SETUP
• Press ENTER to select ALARM SETUP
• Press ENTER to select RATE ALARMS
If alarm is OFF, switch the alarm ON as previously explained in Section 4.1.2
• Press LINE 2 twice to move the focus to ALARM POINT
• Press ENTER to edit the value.
An asterisk(*) will be displayed
• Press INC/DEC buttons, to set the ALARM POINT as a percentage (%).
• Press ENTER to accept the changes.
42
V 1.0 11/05
To Next Page
Loading...