E15h SPRAYER- Alarm Setup
4.2.7 ENABLE THE AUX SHAFT HIGH ALARM
• Press MENU
• Press ENTER to select SETUP
• Press LINE 2 the focus is on ALARM SETUP
• Press ENTER to select ALARM SETUP
• Press LINE 2, the focus is on SHAFT ALARMS
• Press ENTER to select SHAFT ALARMS
• Press LINE 4, the focus is on AUX SHAFT HIGH
• Press ENTER to edit AUX SHAFT HIGH.
An asterisk (*) will be displayed
• Press INC/DEC buttons, to enable the alarm ON or OFF
• Press ENTER to accept the changes
4.2.8
SET THE AUX SHAFT HIGH ALARM POINT
• Press MENU
• Press ENTER to select SETUP
• Press LINE 2 the focus is on ALARM SETUP
• Press ENTER to select ALARM SETUP
• Press LINE 2, the focus is on SHAFT ALARMS
• Press ENTER to select SHAFT ALARMS
Note: If alarm is OFF, to switch the alarm ON, see Section 4.2.7
• Press LINE 4 until the focus is on the ALARM POINT
• Press ENTER to edit the value.
An asterisk (*) will be displayed
• Press INC/DEC buttons, to set the alarm point in 50rpm increments
• Press ENTER to accept the changes
47
V 1.0 11/05
To Next Page
Loading...