Eagle KEE E15 - Page 5

7. OPERATIONS: SPRAYER 66
7.1 OPERATION OF THE SPRAYER 67
7.1.1 DISPLAY THE VOLUME REMAINING IN THE TANK 67
7.1.2 DISPLAY THE VOLUME USED 67
7.1.3 FILL THE TANK 67
7.1.4 FILL THE TANK TO A SET VOLUME 67
7.1.5 TO DISPLAY SUB AREA, TOTAL AREA AND SUB AREA NUMBER 67
7.1.6 TURN A SECTION ON 67
7.1.7 TO CLEAR A SUB AREA 68
7.1.8 TO CHANGE THE SUB AREA NUMBER 68
7.1.9 RESET TOTAL AREA 68
7.1.10 SELECT BETWEEN MANUAL AND AUTO SPRAYING 68
7.1.11 SELECT BETWEEN COVERAGE RATE, ROW WIDTH, PRESSURE1,
& FAN SPEED1 69
7.1.12 SELECT BETWEEN FLOW RATE,PUMP SPEED,AUX SHAFT SPEED
& FAN SPEED 69
7.1.13 SELECT BETWEEN VOLUME LEFT AND FLUSH FUNCTION 70
7.1.14 SELECT BETWEEN VOLUME USED, AUX FUNCTION, DUMP OVERRIDE
& DATA 70
7.1.15 SELECT ROW WIDTH 70
7.1.16 ACTIVATE FLUSH FUNCTION 71
7.1.17 ACTIVATE DUMP OVERRIDE FUNCTION 71
7.1.18 ACTIVATE AUXILIARY FUNCTION 72
7.1.19 DISPLAY FAN SPEED MONITORING SCREEN 72
7.2 TO BEGIN SPRAYING 73
7.2.1 TO BEGIN SPRAYING (MANUAL MODE) 73
7.2.2 INCREASE OR DECREASE the APPLICATION RATE (MANUAL MODE) 73
7.2.3 BEGIN SPRAYING (AUTO MODE) 73
7.2.4 CHOOSE A PRESET APPLICATION RATE (AUTO MODE) 73
7.2.5 INCREASE OR DECREASE the APPLICATION RATE (AUTO MODE) 73
7.3 OPERATIONS: DATA LOGGER 74
7.3.1 CONNECT THE DATA LOGGER INTERFACE TO THE EAGLE E15H 75
7.3.2 CONNECT A MODULE TO THE DATA LOGGER INTERFACE 75
7.3.3 REMOVE A MODULE FROM THE DATA LOGGER INTERFACE 75
7.3.4 SPRAY TO A PROGRAMMED RATE 75
7.3.5 CHANGE THE JOB NUMBER 76
7.3.6 SPRAY WITHOUT USING PROGRAMMED RATE 76
Table of Contents
Content Page No.
5
V 1.0 11/05