E15h SPRAYER- Alarm Setup
4.3.4
SET THE SPEED HIGH POINT
• Press MENU
• Press ENTER to select SETUP
• Press LINE 2, the focus is on ALARM SETUP
• Press ENTER to select ALARM SETUP
• Press LINE 3, the focus is on SPEED ALARMS
• Press ENTER to select SPEED ALARMS
Note: If alarm is off, turn the alarm on. See Section 4.3.3
• Press LINE 2, until focus is on ALARM POINT
• Press ENTER to edit the value.
An asterisk (*) will be displayed
• Press INC/DEC buttons, to set the alarm point
• Press ENTER to accept the changes
50
V 1.0 11/05
To Next Page
Loading...