Eaton DS7 - Page 166

8 SmartWire-DT
8.9 Programming
162 DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com
Byte 1:
Set value I
r
, trip reasons, acknowledge signal
Byte 2:
Motor current [%]
Byte 3:
Thermal motor image [%]
76543210
ACKR TRIPR TRIPR TRIPR I
r
I
r
I
r
I
r
Data bit Designation Meaning Notes
0 - 3 I
r
Set value I
r
￫ table 29, page 164
4 - 6 TRIPR = Trip
reason
Trip reason ￫ table 30, page 164
7 ACKR =
Acknowledge
required
ZMR manual function
acknowledgement required
0: No acknowledgement
required
1: Acknowledgement of
overload required
￫ section “Overload relay function
(ZMR)”, page 168
76543210
I-REL I-REL I-REL I-REL I-REL I-REL I-REL I-REL
Data bit Designation Meaning Notes
0 - 7 I-REL Motor current [%] ￫ section , “Motor current [%] PKE
(I_REL)”, page 165
76543210
TH TH TH TH TH TH TH TH
Data bit
Designation Meaning Notes
0 - 7 TH Thermal motor image [%] ￫ section , “Thermal motor map on PKE
(TH)”, page 166