Eaton DS7 - Page 196

8 SmartWire-DT
8.9 Programming
192 DS7 Soft starter 09/16 MN03901001Z-EN www.eaton.com
950 0 ro Fault Situations Unsigned16 Number of faults and error
messages that can be stored in
the memory buffer
8 8
1 ro Fault Messages Unsigned16 1 1
952 0 rw FaultSituationCounter Unsigned16 Fault counter: Number of faults
that have occurred since the last
reset
Note:
A reset takes place both when the
unit is switched on and when it is
switched off (up to and including
version V46).
In order to clear the fault counter,
the value has to be set to 0 (in
version V48 and higher).
0 – 65535
962 0 ro SamplingTime Time
Difference
Scan time in ms:
Time required to calculate T2, T4,
and D2.
0 - (2
32
- 1) 100
964 0 ro Manufacturer Unsigned16 Device identification
(DriveUnitIdentification) -
SWD Interface
0 - 65535 265
972 0 rw PowerOnReset Unsigned16 Carries out a restart:
Notice:
Modified parameters will not be
saved. In order to save the
parameters, PNU 977.0 must be
set to 1.
0; 1 0
975 Drive Object
Identification
Drive identification
0 ro Manufacturer Unsigned16 0 - 65535 9
1 ro Drive Unit Type Unsigned16 0 - 65535 16
2 ro Version (SW) Unsigned16 0 - 65535 66
3 ro Firmware date (Year) Unsigned16 0 - 65535 221
4 ro Firmware date (day/
month)
Unsigned16 0 - 65535 83
5 ro DO Class Unsigned16 0 - 65535 0
6 ro DO sub class Unsigned16 0 - 65535 0
7 ro DO-ID Unsigned16 0 - 65535 0
8 ro reserved Unsigned16 0 - 65535 0
9 ro reserved Unsigned16 0 - 65535 0
10 ro Manufacturer Specific Unsigned16 0 - 65535 0
976 0 rw FactorySettings Unsigned16 Resets all parameters to their
default setting.
0; 1 0
977 0 rw SaveParameters Unsigned16 Stores all parameters in internal
memory.
0; 1 0
PNU
Index
PNU
Sub-
index
Access
rights
Designation Data type Meaning Value range DS User
setting