10-4 IM02601001E www.eaton.com
Setup on the Web Server Pages
Ethernet/LAN Setup Edit
In addition to network settings, you can also add location, contact, and asset ID informa-
tion.
The meter has two types of triggers:
• triggers provide set points for issuing alarms for any of the supported
electrical measurements. You can also set a hysteresis value for these to avoid rapid,
multiple trips from a value that hovers around the set point.
• has a set of core reset or communications parameters and may in-
clude additional communication or reset parameters from option cards. These param-
eters reect device status and not electrical measurements.
You can use the page to set hi and low cautionary and critical
alarms for a wide range of electrical parameters (see page 9-12 for a complete list of
parameters). For a detailed discussion of triggers, see page 9-12. Triggers can cause
the following actions:
An event is added to the event log, and can be seen in the • Events page.
The event indicator at the top of each meter page ashes.•
The event information is sent via SNMP as a trap. SNMP is a standard protocol used •
to monitor and manage devices on a network. The trap protocol allows a node (such
as the meter) to send a message to SNMP monitoring/management software without
being queried.
The event information is sent as an RSS (Atom) feed. You can subscribe to the me-•
ter’s Atom feed by clicking the RSS icon at the top, right side of the page. In the RSS
To Next Page
Loading...
