5-4 IM02601001E www.eaton.com
Serial Communication Installation
PXM 2000 Series Transducer Communication Information
The PXM 2000 Series Transducer does not include a display or buttons on the front face of the meter. Programming
and communication utilize the RS485 connection on the back face of the meter shown in section 5.1.2. Once a
connection is established, Eaton Meter Conguration Software can be used to program the meter and communicate
to slave devices.
Meter Connection
To provide power to the meter, attach an to GND, L(+) and N(-) Refer to Chapter 4, Figure 1.
The RS485 cable attaches to SH, B(-) and A(+) as shown in Figure 5.3 of this chapter.
To Next Page
Loading...
