2 IM02601001E www.eaton.com
Introduction
All safety codes, safety standards, and/or regulations must be strictly observed in the installation,
operation, and maintenance of this device.
refer to instructions that, if not followed, can result in death or injury.
refer to instructions that, if not followed, can result in equipment damage.
:
Follow all Warnings and Cautions. Completely read and understood the information in this
document before attempting to install or operate the equipment. Improper wiring could cause
death, injury, or equipment damage. Only qualied personnel are to service the PXM 2000 Series.
Exercise extreme care to avoid injury or death. Always disconnect,
lock-out, and tag the current and voltage sources and the control power supply circuit before
touching the connections or components on the rear face of the meter base unit.
Properly ground the meter during installation.
To Next Page
Loading...
