10-18 IM02601001E www.eaton.com
Setup on the Web Server Pages
The page is divided into two sections: Hardware and System Firmware.
Hardware Setup - Faceplate Setup
You can congure the meter’s faceplate display. Options include:
• . This eld determines which phases
display on the faceplate. For example, if you select A and B, only those two phases
will be displayed on the faceplate.
• This eld enables or disables the scrolling of selected readings on the
faceplate. If enabled, the readings scroll every 5 seconds.
• : Check the boxes of the readings you want displayed on
the faceplate of the meter. You must select at least one reading.
Faceplate Display Setup Page
The Power Xpert Meter uses a real-time clock for time keeping. The meter can be cong-
ured to adjust for Daylight Savings Time (DST) based on the time zone selection and to
synchronize time using NTP. By using NTP, time will be maintained by the real time clock,
and the real time clock will be calibrated and time corrected using NTP.
The page allows you to set the time in hours and minutes (in 24 hour
time), select a time sync option, and set the date for the meter. If NTP is selected for time
synch, an IP address of the NTP server should be set. When selecting NTP (Network
Time Protocol) as the Time Sync Source, at least one IP Address must be entered (as
many as three NTP server IP addresses may be entered). A list of public NTP servers is
available at: http://support.ntp.org/bin/view/Servers/WebHome.
The and Date format settings only affect logs and e-mails.
To Next Page
Loading...
