10-10 IM02601001E www.eaton.com
Setup on the Web Server Pages
Serial Communications Setup Page
Communications Settings - E-mail Setup
The PXM 2000 meter provides a highly congurable capability to report on meter activ-
ity via email. This is just like conguring an email application such as Outlook Express
or Thunderbird. If you are unsure as to how to do this, ask your information technologies
group or the person in charge of your mail server for assistance. You can congure:
The SMTP server, including the server and account information. You’ll need the follow-•
ing information from your system administrator to enter under Global email congura-
tion. The meter cannot communicate using the Microsoft exchange email protocol.
A valid email account (user name and password). •
The address of the SMTP mail server. •
The email address of the account. Each meter can be assigned a separate email •
account. This allows you to easily determine which meter sent the email through
its address.
Email triggers. The meter will send emails in response to any event trigger that has •
been enabled for email, and this set includes a core set of hardware and communica-
tions failure triggers that you can also select. The contents of this list are dependent
on the option card installed in the meter.
Recipient specic settings for up to 10 email recipients. This includes settings for •
sending emails when an event occurs and/or clears and for sending periodic status
emails. You can congure the email address for each recipient by selecting a recipi-
ent through the Recipient drop-down list and then conguring the recipient’s address
information by clicking the Edit button.
The following example is typical of the status emails sent by the meter:
Power Xpert Meter Status Report
Device=Power Xpert Meter 2000 Gateway Card