Eaton Pow-R-Line SPX0361126 - Page 563

V10-T2-2 Volume 10—Enclosed Control CA08100012E—August 2012 www.eaton.com
2
2.1
NEMA Contactors and Starters
Freedom Full Voltage Controls
Freedom Full Voltage Controls
Product Description
Eaton’s Freedom Series™
starters and contactors
feature a compact, space-
saving design, high strength,
impact and temperature
resistant insulating materials.
Features
●
Adjustable bimetallic
ambient compensated
overload relays with
interchangeable heater
packs—available in three
basic sizes, covering
applications up to 900 hp—
reducing the number of
different contactor/
overload
relay combinations
that
have to be stocked
●
Fixed heater overloads
optional
●
Electronic/solid-state
overload optional
●
A full line of snap-on
accessories—top and
side mounted auxiliary
contacts, solid-state and
pneumatic timers, and
so on
●
Straight-through wiring—
line lugs at top, load lugs at
bottom
●
Horizontal or vertical
mounting on upright panel
for application freedom
●
Screw type power
terminals have captive,
backed-out self-lifting
pressure plates with ±
screws—reduced wiring
time
●
Accessible terminals for
easy wiring. Optional
fingerproof shields available
to prevent electrical shock
●
Top located coil terminals
convenient and readily
accessible. 45 mm
contactor magnet coils
have three terminals,
permitting either top or
diagonal wiring—easy to
replace European or U.S.
style starters or contactors
without changing wiring
layout
●
Encapsulated dual voltage/
frequency magnet coils—
permanently marked with
voltage, frequency and part
number
●
Designed to meet or
exceed UL, CSA
®
, IEC,
VDE, BS and other
international standards
and listings
Standards and
Certifications
Note: See Ta b 1 7 for additional
information on standards and
certifications that apply to all
enclosed control products.
●
UL Listed
●
cUL
®
Listed (indicates
appropriate CSA Standard
investigation)
●
ABS Type Approved
●
OSHPD Certified
(OSP-0015-10)
Certified Type 2 Coordination
Eaton’s Freedom Series
NEMA starters are UL
Certified to achieve IEC 947
Type 2 coordination against
100,000A short-circuit fault
currents. Any brand of
properly selected fuse can be
used. Type 2 coordination
means that the starter will be
suitable for further use
following a short-circuit fault.