Volume 10—Enclosed Control CA08100012E—August 2012 www.eaton.com V10-T2-5
2
2.1
NEMA Contactors and Starters
Freedom Full Voltage Controls
Cover Control
Non-Combination Starters
Control Power Transformer
(CPT) may be required.
Combination Starters
●
Cover control for
combination starters uses
10250T style devices as
standard
●
Selector switches are
maintained with lever
operators
●
Pushbuttons are
momentary type with
extended pushbutton
●
The kit includes hardware
and connecting wires
(where possible)
●
For factory installed
control devices other
than shown below, refer
to modification codes,
Ta b 1 5
Product Selection
Type 1 Non-Combination Cover Control
Notes
1
For more available factory installed flange control, see Page V10-T2-6.
2
Add code letter from the table below to catalog number for voltage—kits only. Example: C400GK0B.
Description
Factory Installed
Flange Control
1
Position 9 Cover
Control Code
Field Installation Kits
Catalog Number
Non-Reversing
No cover mounted pilot devices A C400GK0
START/STOP pushbuttons B C400GK1
With red RUN pilot light C C400GK12
2
With red RUN/green OFF lights D C400GK16
2
HAND/OFF/AUTO selector switch H C400GK3
With red RUN pilot light J C400GK32
2
With red RUN/green OFF lights K C400GK36
2
Red RUN pilot light P C400GK42
2
Green OFF Q C400GK41
2
Red RUN/green OFF pilot lights R C400GK46
2
Reversing
No cover mounted pilot devices A C400GK0
FOR/REV/STOP pushbuttons B C400GR1
With two red pilot lights C C400GR14
2
UP/STOP/DOWN pushbuttons E C400GR2
With two red pilot lights F C400GR24
2
Two red pilot lights P C400GK44
2
One green pilot light Q C400GK41
2
Rating Code Letter Rating Code Letter Rating Code Letter
120V 60 Hz A 277V 60 Hz H 480V 60 Hz C
208V 60 Hz E 380V 50 Hz L 600V 60 Hz D
240V 60 Hz B
To Next Page
Loading...
