103
CANopen external communication cards
POWERXL DG1 SERIES VFD MN040010EN—September 2016 www.eaton.com
Commissioning
The CANopen board is commissioned by inserting it into
Slot A and Slot B ports on the control board. Once the
card is inserted to the slot, the device will recognize it and
will show a warning for “Device Added.” This warning will
be shown for 5 seconds and will clear. Once the card is
detected, the keypad will show the menu for the card in the
Optional Card Menu.
Option card parameters
Once the card is detected, the following parameters can be
set on keypad for CANopen.
Figure 44. CANopen parameters
To Next Page
Loading...
