Eaton PowerXL DG1 Series - Commissioning; Figure 50. Devicenet Parameters

125
DeviceNet external communication cards
POWERXL DG1 SERIES VFD MN040010EN—September 2016 www.eaton.com
Commissioning
The DeviceNet board is commissioned by inserting it into
Slot A and Slot B ports on the control board. Once the card
is inserted into the slot, the device will recognize it and
will show a warning for “Device Added.” This warning will
be shown for 5 seconds and will clear. Once the card is
detected, the keypad will show the menu for the card in the
Optional Card Menu.
Option card parameters
Once the card is detected, the following parameters can be
set on keypad for DeviceNet.
Figure 50. DeviceNet parameters