Eaton PowerXL DG1 Series - Figure 14. Static IP Mode

21
Modbus TCP On-Board communications
POWERXL DG1 SERIES VFD MN040010EN—September 2016 www.eaton.com
Manual IP address configuration
Using the PowerXL drive keypad
Using the PowerXL Drive Keypad to set the IP Address
manually in the PowerXL EtherNet/IP.
1. Select IP addressing mode as Static IP. Static IP
mode configurations will be loaded.
ote:N Change in IP address mode will require PowerXL to
power cycle to get this change effective. Also ensure
device MAC address (Keypad menu. P20.3.5)
Figure 14. Static IP mode