Eaton PowerXL DG1 Series - Figure 25. Static Subnet Mask; Figure 26. Static Default Gateway

39
EtherNet/IP On-Board communications
POWERXL DG1 SERIES VFD MN040010EN—September 2016 www.eaton.com
b. Setting Static Subnet Mask
Figure 25. Static subnet mask
c. Setting Static Default Gateway
Figure 26. Static default gateway
3. Make note of the changed IP Address.
4. Using PowerXL drive keypad, read “Active IP Address”
(Keypad menu. P20.3.2), “Active Subnet Mask” (Keypad
menu. P20.3.3), “Active Default Gateway” (Keypad
menu. P20.3.4) parameters to ensure that IP address
has been set to desired IP address.