Eaton PowerXL DG1 Series - Table 170. Instance 107 (Input) Length = 8 Bytes

132
DeviceNet external communication cards
POWERXL DG1 SERIES VFD MN040010EN—September 2016 www.eaton.com
Assembly instance 107
Table 170. Instance 107 (Input) length = 8 bytes
Byte Bit 7 Bit 6 Bit 5 Bit 4 Bit 3 Bit 2 Bit 1 Bit 0
0 AtReference RefFromNet CtrlFromNet Ready Running2 Running1 Warning Faulted
1
Drive State 
2
% Speed Actual (Low Byte) 
3
% Speed Actual (High Byte) 
4 Process DataOut1 (Low Byte)
5 Process DataOut1 (High Byte)
6 Process DataOut2 (Low Byte)
7 Process DataOut2 (High Byte)
 Refer “State transition diagram,” provided under “Control Supervisor Object” and “Drive State” table specified at
end of “Input Instances” section.
Drive State
0x00 DN_NON_EXISTANT
0x01 DN_STARTUP
0x02 DN_NOT_READY
0x03 DN_READY
0x04 DN_ENABLED
0x05 DN_STOPPING
0x06 DN_FAULT_STOP
0x07 DN_FAULTED
 Speed Actual. This is the actual value from the frequency converter. The value is between 0 and 10000. In the application,
the value is scaled in percentage of frequency area between set minimum and maximum frequency.
(0 = 0.00%–10000 = 100.00%).
ote:N See info on Assembly 101 for varying values in the Process Data Out 1 and Process Data Out 2 Bytes. See Appendix B
on default Process Data info.