Eaton PowerXL DG1 Series - Page 194

171
Appendix C—Fault codes
POWERXL DG1 SERIES VFD MN040010EN—September 2016 www.eaton.com
Table 191. Fault Code List, continued
Fault
Code Fault Name Fault type Default Realization
CIP
Fault code
PROFIdrive
fault code
63 Current unbalance Fault DSP 26d 9056
64 Replace battery Configurable Warning MCU 0xA019h 35345
65 Replace fan Configurable Warning MCU 0xA01Ah 28688
66 Safety torque off Fault DSP 0x A01Bh 21665
67 Current limit control Warning DSP 0x2200h 8977
68 Over voltage control Warning DSP 0x3310h 12817
69 System Fault - Thermistor SPI Fault MCU 0xA01Ch 21009
70 System Fault - DSP Parameter Fault MCU 0xA01Dh 22018
71 System Fault - Intercom Fault MCU 0xA01Eh 22019
72 Power board EEPROM fault Fault MCU 0xA01Fh 22305
73 Internal FRAM Fault MCU 0xA020h 22033
74 FRAM data error Fault MCU 0xA021h 21809
75 Internal power board EEPROM fault Fault MCU 0xA022h 22035
76 EEPROM Data error Fault MCU 0xA023h 21808
77 Internal serial flash Fault MCU 0xA024h 22051
82 Bypass overload Fault MCU 0xA025h 28980
83 FieldBus fault Configurable Fault MCU 0xA026h 30064
84 FieldBus fault Configurable Fault MCU 0xA027h 30065
85 FieldBus fault Configurable Fault MCU 0xA028h 30066
86 FieldBus fault Configurable Fault MCU 0x8100h 30067
87 FieldBus fault Configurable Fault MCU 0xA029h 30068
88 FieldBus fault Configurable Fault MCU 0xA02Ah 30069
89 Under voltage Fault DSP 0xA02Bh 30070
90 Drive UnderTemp Warning/Fault DSP 0x3221h 30071
91 Option card fault Fault MCU 0xA02Ch 30072
92 External fault 2 Configurable Fault MCU 0xA02Dh NA
93 External fault 3 Configurable Fault MCU 0xA02Eh NA
94 Pump lost Warning MCU 0xA02Fh 58881
95 Need alternation Warning MCU 0xA030 58882
96 Parameter error Warning MCU 0x6320 33072
97 Prime loss Configurable No Action MCU 0xA031 35587
98 PID1 feedback AI loss Configurable No Action MCU 0xA032 33283
99 PID2 feedback AI loss Configurable No Action MCU 0xA033 33284
ote:N Configurable—Faults that are specified as “Configurable” have “Fault configuration
parameter” associated with them. This configuration parameter can be configured as
using keypad (menu P9. Protections) or using PowerXL EIP vendor specific object.