2019.07.11
© 2017 Eaton. All rights reserved
100
TRSM0940 Service Procedures | MHP/MXP/VHP/VXP Splitter Cylinder Disassembly and Assembly
4. Position new gasket on the Cylinder Housing, and
install the Splitter Cylinder
5. Install
O-Ring on the end of the yoke bar inside of the
Cylinder Housing
6. Install the O-ring on
the ID and OD of the piston.
7. Install Piston into the
bore of the Range Cylinder Install
with the flat side of the piston facing rearward.
8. Position new gasket on
the Cylinder Housing Cover
mounting surface and install the Splitter Cylinder Cover
Note: Ensure
that the gasket air passage aligns with
the housing air passage
To Next Page
Loading...