Eaton UltraShift PLUS Series - Release Yoke and Cross-Shaft(S) Installation

2018.12.12
© 2017 Eaton. All rights reserved
196
TRSM0940 Service Procedures | Release Yoke and Cross-Shaft(s) Removal and Installation
5. Remove the upper Cross-Shaft Seal assembly.
6. If necessary, remove the 2 upper Cross-Sha
ft Bush-
ings.
Release Yoke and Cross-Shaft(s) Installation
1. If previously removed, install the 2 upper Cross-Shaft
Bushings.
Note: Make sure to
apply grease to the bushings.
2. If
previously removed, install the upper Cross-Shaft
Grease Seal.