Eaton UltraShift PLUS Series User Manual

2018.12.12
© 2017 Eaton. All rights reserved
220
TRSM0940 Service Procedures | Input Shaft Speed Sensor Removal and Installation
Input Shaft Speed Sensor Removal
1. Disconnect the Transmission Harness from the Input
Shaft Speed Sensor or pigtail connector, if equipped.
2. Using
a 3/8” socket, remove the sensor retaining bolt.
3. Remo
ve the Input Shaft Speed Sensor, with O-ring,
from the Transmission Shift Bar Housing.

Eaton UltraShift PLUS Series Specifications

General

Brand	Eaton
Model	UltraShift PLUS Series
Category	Microphone system
Language	English