159
© 2017 Eaton. All rights reserved
2018.12.12
Oil Pump and Lube Tube Installation | Service Procedures TRSM0940
24. Install a new spiral lock retainer on the upper Reverse
Idler Shaft.
25. Remove the
rear Main Shaft Bearing and pull the
Reverse Gear back into place in between the two
Reverse Idlers. Ensure the Reverse Gear is pulled as far
to the rear of the case as possible.
Note: Placing
a hand maul in between the 1st and
Reverse Gear will assist in keeping the Reverse Gear in
position.
26. Install the
keyed washer into the Reverse Gear. The
washer should rest on the upper edge of the snap ring
groove of the Reverse Gear.
Note:
When installing, the washer can drop in front of
the gear and rest on the Main Shaft.
27. Install the
Reverse Gear snap ring, place one corner
into the groove in the gear and, using two small screw-
drivers, pry it into place working slowly around
the
Main Shaft unit the snap ring is fully seated.
To Next Page
Loading...