235
© 2017 Eaton. All rights reserved
2018.12.12
Tool Specifications | Appendix TRSM0940
Special Tools
The following special tools are designed for this Eaton®
Fuller® Transmission. The address and phone number of
the tool supplier are listed after the table. This list is pro-
vided as a convenience to our customers. These tools are
manufactured
by an independent company with no relation-
ship to Eaton® Fuller®. Eaton
® Fuller® does not warrant
the fit or function of the listed tools. To obtain the tools,
contact the tool supplier directly.
Eaton® Aftermarket Parts
The following tools are available through Eaton® Aftermar-
ket Parts. To obtain any of the tools listed
, contact your
local Eaton® parts distributor.
Roadranger Tool Number Tool Purpose
Output Yoke Puller May be required to remove a rusted Output
Yoke
RR1006TR Auxiliary Section Hanger Support, or hang, the Auxiliary Section in the
h
orizontal position
RR1007TR Auxiliary Counter Shaft Su
pport and Shim
Tool
Hold the Auxiliary Counter Shafts in position
while installing the Auxiliary Section in the
horizontal position, also to simplify the
checking and setting of the Auxiliary Counter
Shaft Bearing endplay
RR1012TR-3 Bearing Puller Remove front section Counter Shaft Bear-
ings
RR1012TR-2 Bearing Driver Install front section Counter Shaft Bearings
RR1012TR-4 Bearing Driver Install the front Counter Shaft
Rear Bearings
RR1002TR Counter Shaft Support Tools (2) Support and locate the front section Counte
r
Shafts during bearing removal and installa-
tion
RR1005TR Input Bearing Driver Install Input Bearing on Input Shaft
RR1012TR-5 Bearing Driver Install the Auxiliary Counter Shaft Tapered
Bearings
RR1004TR Main Shaft Hook Assist in lifting of Main Shaft
from front sec-
tion
RR1023TR Input Bearing Puller Remove Input Bearing
RR1011TR Bearing Race Puller Remove the Auxiliary Counter Shaft Tapered
Bearing Outer
Races
RR1001TR Output Seal Driver Install Output Seal
RR1001TR-1 Output Seal Slinger Driver Install Output Seal Slinger