Eaton XC-303 Series - Page 108

7 Defining system parameters
7.4 networkconfig file
Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… 01/23 MN050005EN Eaton.com 103
#--------------------------------------------
# ETH 1
#--------------------------------------------
ETH1_DISABLE=
# 1 will disable the interface.
# Default value:0
ETH1_ENABLE_DHCP=
# 1 will enable dhcp client on the interface.
# Default value:0
ETH1_IP_ADDRESS=
# Should containg a valid IP-v4 ip-address,
# if DHCP is enabled this field must be left blank.
# Default value:192.168.137.248
ETH1_SUBNET_MASK=
# Should containg a valid IP-v4 subnet mask
# Default value:255.255.255.0
ETH1_BROADCAST=
# Should containg a valid broadcast address
# Default value:255.255.255.255
ETH1_DEFAULT_GATEWAY=
# Should containg a valid IP-v4 ip-address of the default gateway.
# Default value: no default value.
#--------------------------------------------
# ETH 2
#--------------------------------------------
ETH2_DISABLE=0
# 1 will disable the interface.
# Default value:0
ETH2_ENABLE_DHCP=
# 1 will enable dhcp client on the interface.
# Default value:0
ETH0_IP_ADDRESS=
# Should containg a valid IP-v4 ip-address,
# if DHCP is enabled this field must be left blank.
# Default value:192.168.138.248
ETH0_SUBNET_MASK=
# Should containg a valid IP-v4 subnet mask
# Default value:255.255.255.0
ETH0_BROADCAST=
# Should containg a valid broadcast address
# Default value:255.255.255.255
ETH2_DEFAULT_GATEWAY=
# Should containg a valid IP-v4 ip-address of the default gateway.
# Default value: no default value.