Eaton XC-303 Series - Web Visu XSOFT-CODESYS-3; Opening XSOFT-CODESYS-3 Webvisu; Selecting the XSOFT-CODESYS-3 Webvisu Encryption Type

13 Web Visu XSOFT-CODESYS-3
13.1 Opening XSOFT-CODESYS-3 WebVisu
Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… 01/23 MN050005EN Eaton.com 133
13 Web Visu XSOFT-CODESYS-3
Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… feature a web
server used to deploy the visualization generated by XSOFT-CODESYS-3.
The way the web visualization is handled is explained in the XSOFT-CODE-
SYS-3 Help.
Keywords: CODESYS visualization / "Web Visu" object
13.1 Opening XSOFT-CODESYS-3 WebVisu
A description of the web visualization interface can be found in section 7.4,
"Web visualization", of the manual for programming PLCs with CODESYS.
The visualization can be accessed through any of the Ethernet interfaces on
the Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-….
However, this requires for a corresponding webvisu.htm XSOFT-CODESYS-3
WebVisu project to be found on the device already.
If the device is addressed through Ethernet port ETH2 with the default IP
address, for example, the XControl-specific web visualization call will be as
follows:
Unencrypted: http://192.168.138.248:8080/webvisu.htm
Encrypted: https://192.168.138.248/webvisu.htm
If you have changed the IP address, replace the IP address in the “http:\\...”
call with the address you have selected.
13.2 Selecting the XSOFT-CODESYS-3 WebVisu encryption type
The web server for XSOFT-CODESYS-3 projects can be accessed either with
the HTTP or HTTPS protocol. The 3S CODESYSControl.cfg file specifies
which of the protocols should be available.
This file can be found on the device, in the "\home\PlcRts" directory.
ATTENTION
The number of clients that can access the Modular PLCs XCon-
trol: XC-104-…, XC-204-…, XC-303-… simultaneously is limited
to 10.