Eaton XC-303 Series - Date & Time Configuration Page; Date & Time; Time Synchronization with NTP

14 Web Config Tool for XC-104-… and XC-204-…
14.7 Date & time configuration page
Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… 01/23 MN050005EN Eaton.com 147
14.7 Date & time configuration page
The "Date & time" configuration page will show the current device time with-
out taking into account the local device's time zone.
Figure 114: "Date & time" configuration page
14.7.1 Date & Time
You can set the time, including the corresponding seconds, and the time
zone. If you change the time zone, the time shown above will not be re-cal-
culated.
14.7.2 Time synchronization with NTP
In the "Time synchronization with NTP" section, you can enable NTP and
select a preferred address and a backup address. The NTP service will then
be used to correct the time and the system time every minute. This can also
help counteract RTC drift if the device runs for multiple years or decades.