Eaton XC-303 Series - Remote Access Configuration Page; Ssh; Vnc

14 Web Config Tool for XC-104-… and XC-204-…
14.8 Remote access configuration page
148 Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… 01/23 MN050005EN Eaton.com
14.8 Remote access configuration page
You can use the "Remote access" configuration page to enable and disable
the corresponding service.
Figure 115: "Remote access" configuration page
14.8.1 SSH
You can enable and disable remote access in the "SSH" section.
14.8.2 VNC
In the "VNC" section, you can enable/disable the service and define the cor-
responding login information, port, timeout, and encryption. The timeout is
the time after which a client will automatically terminate the connection. If
you change the password, a dialog box will appear so that you can enter the
new password twice.
￫
Make sure to disable SSH after you no longer need it and the
device is in a production environment. This will disable remote
access and improve the device's security.
￫
Make sure to disable VNC after you no longer need it and the
device is in a production environment.