14 Web Config Tool for XC-104-… and XC-204-…
14.5 Network configuration page
Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… 01/23 MN050005EN Eaton.com 143
A factory reset can also be carried out by plugging in a storage device into
the device's USB port and booting the device – please refer to ￫ Section “
Enable/disable USB factory reset.”, page 141.
14.4.6 Powerfail
To keep data retentive, it will be copied from RAM to NVRAM when the
device is switched off. As soon as the data has been stored, the time until
the device is de-energized will be counted up. This time will be shown in the
"Powerfail" section.
If this time falls below a value of 10 ms, an error message will appear in
order to let you know that the data can no longer be stored in a retentive
manner.
There are two possible causes for this error message:
1. The remaining time has decreased due to the components getting older.
2. The operating system is in an error condition.
Figure 110: System configuration – Powerfail section
14.5 Network configuration page
The number of "Network interfaces" sections that you can use to set up the
IP configuration for each interface will depend on the specific number of net-
work interfaces on the device.
To Next Page
Loading...
