Eaton XC-303 Series - Creating the Event-Triggered Task and Defining the Program Call

4 PLC configuration
4.1 Task configuration
Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… 01/23 MN050005EN Eaton.com 75
Figure 50: Creating a program element for a cyclic task
4.1.2 Creating the event-triggered task and defining the program call
The procedure corresponds to the creation of a cyclic task.
▶ Create a task of type "Event" named "Event" as shown in Figure 51.
▶ Enter global Boolean tag "a" as the event by clicking on the ... button,
double-clicking on the "GVL" folder in the "Input assistance" dialog box,
selecting tag "a", and confirming with "OK".
▶ Enter the program call "Event_prog".
Figure 51: Creating an event controlled task