14 Web Config Tool for XC-104-… and XC-204-…
14.4 Device configuration page – System configuration page
Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… 01/23 MN050005EN Eaton.com 141
Figure 106: Change password
Once you create a password, it will be possible to change it but not to delete
it (unless you carry out a factory reset) – please refer to
14.4.3 USB interface activation
Enable USB
In the "USB" section, you can enable the USB interface by toggling the cor-
responding switch to the right and disable it by toggling it to the left. If the
USB interface is not enabled, USB Autostart and USB factory resets will not
be possible.
Enable/disable USB Autostart
The USB Autostart function is used to automatically start executable files on
a plugged-in USB storage device when the device is booting up.
If USB Autostart is enabled, the system will search for shell scripts named
"etn-startup.sh" in the root directory of the partitions on a plugged-in USB
drive and run them with a GNU Bash interpreter.
To Next Page
Loading...
