19 Maintenance
19.4 Disposal
166 Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… 01/23 MN050005EN Eaton.com
The ambient conditions must be met when transporting and storing the
device.
The ambient air temperature for storage / transportation must not exceed the
maximum specified limit:
▶ Use the original packaging to ship the device.
The device is sturdily built, but the components inside it are sensitive to
excessively strong vibrations and/or mechanical shock.
Accordingly, make sure to protect the device from mechanical loads that
exceed the scope of the unit's intended use.
The device should only be transported in its original packaging after being
packed properly.
19.4 Disposal
CAUTION
SHORT-CIRCUIT HAZARD
If the device is or has been exposed to environmental fluctua-
tions (ambient temperature, air humidity), condensation may
form on or inside it. As long as this condensation is present,
there will be a short-circuit hazard.
Do not switch on the device when it has condensation in or on
it.
If the device has condensation in or on it, or if the panel has
been exposed to environmental fluctuations, let the panel settle
into the existing ambient temperature before switching it on. Do
not expose the device to direct thermal radiation from heating
appliances.
￫
Before commissioning
If storing/transporting the device in cold weather conditions or in
such a way that it will be exposed to extreme differences in
temperature, make sure that no condensation forms on or
inside the device.
If there is condensation in or on the device, do not switch on the
device until it is completely dry.
CAUTION
Installation requires qualified electrician
IMPORTANT!
Dispose of recyclables as required by your local recycling regula-
tions.
To Next Page
Loading...
