19 Maintenance
19.1 Cleaning and maintenance
Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… 01/23 MN050005EN Eaton.com 165
19 Maintenance
19.1 Cleaning and maintenance
The devices are maintenance-free.
However, the following work may be necessary:
• Cleaning the device when soiled.
▶ Carefully clean the device with a clean, soft, damp cloth.
If there are any spots that are proving difficult to get off, spray a little
dishwashing liquid on the damp cloth first.
19.2 Repairs
For repairs, please contact your vendor or Eaton's Technical Support.
Contact your local supplier or Eaton technical support for repairs.
Use the original packaging to ship the device.
19.3 Storage and transport
CAUTION
POINTY, SHARP OBJECTS AND CORROSIVE LIQUIDS
Do not use any pointy or sharp objects (e.g., knives)
for cleaning. Do not use aggressive or abrasive cleaning prod-
ucts or solvents.
Make sure that no liquids get into the device (short-circuit haz-
ard) and that the device is not damaged in any way.
CAUTION
DESTRUCTION
The device should only be opened by the manufacturer or by an
authorized repair center. Operate the device until only with the
enclosure fully closed and sealed.
CAUTION
UV LIGHT
Plastics will become brittle when exposed to UV light.
This artificial aging will reduce the device's lifespan. Protect the
device from direct sunlight and other sources of UV radiation.
To Next Page
Loading...
