14 Web Config Tool for XC-104-… and XC-204-…
14.4 Device configuration page – System configuration page
142 Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… 01/23 MN050005EN Eaton.com
Enable/disable USB factory reset.
The ability to reset the device to factory settings will be enabled (i.e., avail-
able) if you toggle the "Enable USB factory reset" switch to the right. For
information on how to reset the XControl device to factory settings, please
refer to ￫ Section “3.10 Factory resetting XC-104-… and XC-204-…”, page
71.
Figure 107: Device configuration page – USB section
14.4.4 Power management
You can restart and shut down the device in the "Power management" sec-
tion. To prevent the device from being shut down or restarted accidentally,
you will need to confirm these actions in a confirmation prompt.
Figure 108: System configuration – Power management section
14.4.5 Factory reset
In the "Factory reset" section, you can reset your device directly tofactory set-
tings without the need for additional preparation. A confirmation prompt will
appear after you click on the button. If you confirm the "factory reset," the
prompt will disappear.
Figure 109: System configuration – Factory reset section
All Ethernet ports will be reset to their default settings. If a password has
been set, it will be deleted.
To Next Page
Loading...
