Eaton XC-303 Series - Factory Reset; Resetting the Device to Factory Settings

4 PLC configuration
4.8 Factory reset
Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… 01/23 MN050005EN Eaton.com 87
4.8 Factory reset
4.8.1 Resetting the device to factory settings
If you want to reset the device to factory settings, you can use either the
XControl web configuration server or the native configuration tool (on XV
devices).
If you use the XControl web configuration server, follow the steps below:
▶ First log in to the device
▶ Go to the "Device" configuration page.
▶ Click on the "Factory reset" button. A confirmation prompt will appear.
▶ Confirm with OK. If you do not confirm the factory reset procedure, the
device will not be reset to its factory settings. You will then have to wait
20 minutes.
▶ Restart the device.
Figure 63: Web Config Tool start page
The device has now been reset to its factory settings.