4 PLC configuration
4.7 Diagnostics
86 Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… 01/23 MN050005EN Eaton.com
▶ In an error scenario, the "Current value" column will contain an error num-
ber and a corresponding description. For instance, the following example
has error number "47" and "The CoDeSys SDIAS configuration is not yet
found on the PLC!" as the description.
Figure 62: "XN300Master Parameters" tab with error message
Display example showing messages for the local XN300 system bus
Shell commands for diagnosing I/O system XN300 modules used
▶ In Explorer, double-click on the device (e.g., "Device (XC-303)") and
select "PLC Shell" under the "Device" tab.
▶ Enter the "?" command into the command line.
￫
For more information on diagnostics, please refer to the
manual for the I/O system XN300,
"XN300 slice modules" and "CANopen Gateway XN-312-
GW-CAN"
To Next Page
Loading...
