7 Defining system parameters
7. 1 O v e r v i e w
Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… 01/23 MN050005EN Eaton.com 99
7 Defining system parameters
7.1 Overview
System parameters independent of the project can be set by you and saved
on the memory card. These parameters will be grouped together on the card
in the following files:
• netwerkconfig.templ -> networkconfig
• deleteboardapplication.templ -> deleteboardapplication
You can also use the memory card in other PLCs. When starting, the PLC will
automatically apply the parameters defined in the files.
• SD/USB in XC-303/update folder
• deleteboardapplication.templ -> deleteboardapplication
Templates on the PLC in the "\home" folder.
7.2 InitPLC file with default parameters
The InitPLC file is always created with all PLC-specific entries.
All parameters are predefined already. The following screenshot shows the
parameters with the corresponding default values, which you can change as
necessary.
#-----------------------------------------------------------
# Comunication Protocols
#-----------------------------------------------------------
# Set to 1 to enable FTP Server. (Unsecure connection)
ENABLE_FTP=0
# Set to 1 to enable telnet Server. (Unsecure connection)
ENABLE_TELNET=0
# Set to 1 to enable SSH Server . (Secure connection, needs a valid
certificate.)
# SSH can be enabled/disabled using the XSoft-Codesys "PLC Shell" command
ssh_access.
ENABLE_SSH=1
# Set to 1 to enable SFTP Server. (Secure connection, needs a valid
certificate.)
# SSH must be activated to use SFTP!
ENABLE_SFTP=1
# Set to 0 to prevent ping response send by the plc.
ENABLE_PING_RESPONSE=1
To Next Page
Loading...
