14 Web Config Tool for XC-104-… and XC-204-…
14.5 Network configuration page
144 Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… 01/23 MN050005EN Eaton.com
Figure 111: Network configuration page with one Ethernet interface
Change the device's IP address
If you change the configuration, you will be disconnected from the Web Con-
fig Tool. if this happens, you will need to log in again with the new IP
address. There are two options: The first one is to use static address assign-
ments, in which case you will have to assign an IP address, a subnet mask, a
default gateway, and a DNS server. The second is to enable the DHCP ser-
vice, in which case a configuration will be automatically requested from your
network – please refer to ￫ Section “14.5 Network configuration page”,
page 143.
You can change the hostname in the "General settings" section. This name
will be used for specific multicast DNS services. This type of service, which
you can use to find the device without knowing the corresponding IP
address, is provided with XSOFT-CODESYS-3.
To Next Page
Loading...
