14 Web Config Tool for XC-104-… and XC-204-…
14.1 Logging in to the Web Config Tool
136 Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… 01/23 MN050005EN Eaton.com
The following screen will appear:
Figure 99: Enter password
The password must meet the following requirements:
• Minimum of 8 characters in length
• At least 1 number
• At least 1 uppercase letter
• At least 1 lowercase letter
• At least 1 special character, with the following characters allowed: ! @ #
$ ^&
After creating the password, you will be automatically authenticated.
Authentication and session
Once you create a password, the login screen will be shown every time you
access the Web Config Tool afterwards.
￫
Please note that the password will not be accepted unless all
the above conditions are met.
￫
Passwords are created during initial commissioning.
To Next Page
Loading...
