2 Installation
2.2 Mounting XControl
Modular PLCs XControl: XC-104-…, XC-204-…, XC-303-… 01/23 MN050005EN Eaton.com 35
▶ Pull the locking elements at the back of the Modular PLCs XControl: XC-
104-…, XC-204-…, XC-303-… and all XN300 slice modules up.
You can use a screwdriver to do this.
Figure 19: Securing the system block on the DIN-rail
▶ Tilt the system block forward and place it against the DIN-rail's bottom
edge in an inclined position.
Figure 20: Placing the system block against the bottom edge of the DIN-rail
▶ Push the system block over the DIN-rail's top edge.
▶ Secure the system block.
To do this, push the locking elements at the back of the Modular PLCs
XControl: XC-104-…, XC-204-…, XC-303-… and all XN300 slice modules
down.
You can use a screwdriver to do this.
To Next Page
Loading...
