60
Technical Publication Document NO: SYSTEM-007-ENG (Ver.1.1)
HF-525Plus Installation, Operation and Service Manual
5.9.7 Generator Setup Method
5.9.7.1 Default mA Setting
Default mA Setting Function is “ON”, and is displayed at LCD Display to set up, and the Default is
200mA, and Data can be changed with necessity.
● Entering by Default mA Setup menu, pushing “KV Up & Down Switch” (Picture 1), and set up Default
mA Value.
● Changed Data can saved using Memory “M” Switch (Picture 5) and pushed until “Beep” ends.
(Buzzer occurs 10 seconds).
To Next Page
Loading...
